Rotary Table with Three-Jaw Chuck

Rotary Table for engraving rings, milling threads etc.

Precise and accurate fixation of the workpiece with ER16 collets.
Definition of the zero via reference switch.
The tailstock serves as the counter bearing.
Suitable for all machines.
You will need the 4th axis module.

The Rotary Table is suitable for STEPCRAFT systems as well as third-party CNC machines. When using the Rotary Table together with the STEPCRAFT Q-Series you need to install additional connection periphery. Please contact us in this case.

Note: For the application of the Rotary Table you are in need of the 4th Axis Module as well as the full version of WinPC-NC USB, UCCNC or a comparable control software.

Technical Specifications:

• Height of spindle: 32 mm
• Over all height: 55 mm
• Width: 42 mm (without shaft)
• With adjustable anti-backlash worm gear, gear reducation 54:1
• With half-step-mode = 21.600 Steps/Turn, 60 Steps/°, 1 Step = 1´ = 60″
• Collets: ER16 (1-12 mm)
• Circular accuracy: 0,1 – 0,2 mm
• Nema 17 stepper motor with 1,8 A 1,8°
• Housing: Aluminum 7075
• All rotating parts are made of stainless steel
• With reference switch
• Horizontal or vertical assembly
• Fixing by M6 screws
• Clamping range with reversible jaws inside from 1,5 – 32 mm / outside from 12 – 65 mm
• Clamping range outside diameter: 50 mm

Scope of Delivery:

• Complete rotary table incl. clamping nut and fixing screws for horizontal assembly
• Lenght of cable: 20 cm (on demand: longer with adequate plug for the 4th axis module)
• With half-step-mode = 21.600 Steps/Turn, 60 Steps/°, 1 Step = 1´ = 60″

Support:
Operating and Safety Instructions Circular Table